The car ball joint is a great way to add a little extra excitement to any dinner party. It’s not as much fun using it on your own as it is letting someone else do the work for you. This particular setup is a simple modification to a standard car ball joint, and it’s pretty simple to make, too.
I’ve had to work with this setup more than once, and I’m quite good at it. I can get the job done quickly, and the results are pretty good. I’m a big fan of adding additional functionality to the joint, so its not all too difficult. The only way I can think of to change the joint and make it work with a plastic ball is to replace the plastic nut and washer with a metal one.
I love this joint; you can do it in less than 10 minutes. Im not sure about the plastic nut and washer, but I think you can easily modify them with a screwdriver. The plastic ball is just a matter of using the appropriate size screwdriver to remove the nut and washer, then sliding the plastic ball over the nut and washer.
If you could find a way to make this joint work with a plastic ball, it might be worth it. It’s such a nice feeling to be able to throw a plastic ball at your enemies and end them with the click of a switch. It’s not too difficult to do, and if you’re willing to put in some hard work and work with a screwdriver, it’s a fun project you can have on the side.
Another common beginner’s mistake is to glue the nut and washer to the plastic ball. Although you can get away with this if you have a very specific budget to get the ball as perfect as possible, most people will just choose to use a small angle grinder and a couple of plastic nuts and washers. It is also possible to use a very specific size and shape of nut and washer and have it work fine.